Getting ready.

On Saturday, I put all the equipment back into the shop, after taking advantage of the great weather in October to weld and finish outside. I also installed an exhaust fan in the shop. It will take the place of the fan that I was using to circulate the air in the shop. With the fan, I had to keep the door open and that let lots of cold air in. I still have not decided on what to do about the heating problem. I do have a large electric heater, that works well when the temp. is not too low; but, the electric cost is high. I did augment that with a kerosene bullet heater, that died after all these years. I have a smaller propane heater; but that is a lot smaller than the kerosene one. I am waiting till I really need more before I buy anything. Maybe another propane one will do.